Hello Tec Netters,
We are de-buging a new circuit board containing a microwave filter operating
in the 2 - 3 Ghz range. This filter was soldered around the perimeter of
the case to the ENIG ground plane using 63/37 eutectic. The engineer is
stating that electrically the filter does not appear to be adequately
grounded to that plane. I am wondering if there is a better way to attach
these filters? Would it be better to solder the entire bottom of the filter
case to the plane? Is anyone using conductive epoxy? Liquid or sheet? I
would appeciate comments.
Thanks,
Jim Kittel
L-3 Communications
---------------------------------------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt delivery of Technet send the following message: SET Technet NOMAIL
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
---------------------------------------------------------------------------------