Hello Technet world:
We sporadically get some micro solder balls in our assemblies using Low solids
flux (Alpha's NR-200). It has been suggested to install a rotating brush after
the wave solder process (to remove some of these solder balls) right before the
exit of the boards. I have my reservations about the solder not being completely
solidified, plus the setup portion, as this brush would have to be adjusted
every time we run a different width board.
Does anyone have such a system installed? Is this a feasible situation? Just
wondering.
Thanks in advance for any responses
Ivan
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in
the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional
information.
If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or
847-509-9700 ext.5365
##############################################################