Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Wed, 5 May 1999 11:31:18 -0700 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Richard,
I have an old set of the Martin Marietta Workmanship Standards, copyright
1988, so I'm not
sure if this is the most current set (4 manuals).
The address I have is :
Martin Marietta
Electronic Systems
POBox 555837 MP-510
Orlando, FL 32855-5837
Hope that helps.
DT
At 11:00 AM 5/5/99 -0700, you wrote:
>Hello all again,
>
>I am interested in what people are using for assembly standards other than
>the 610B. The 610B does a good job addressing the board, but I am interested
>in beyond the board. Of course if you are using something other or in
>addition to the 610B, I would listen with an open ear.
>
>We used to have a book from Martin Merrietta that covered a lot of good
>ground, but we have lost any contact or sourcing information for that.
>
>Thanks in advance for the information.
>
>Richard Hamilton
>Clemar Mfg. / Rain Bird
>[log in to unmask]
>
>################################################################
>TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with
following text in the body:
>To subscribe: SUBSCRIBE TechNet <your full name>
>To unsubscribe: SIGNOFF TechNet
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services"
section for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>
>
>
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|