Tomaso,
You can get the land pattern on the IPC web site: www.ipc.org Go into the
design section and look under tools for the Lnad Pattern Calculator. It will
enable you to either take an existing land pattern or create one with you
preferences for solder fillet sizes.
Regards,
Gary Ferrari
Executive Director
IPC Designers Council
860-350-9300
################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TechNet <your full name>
To unsubscribe: SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################