Jeffrey, Werner et al,

Doesn't this assume that plating in each of the holes is of uniform
thickness but at the same time isn't this rarely the case?  Does this not
also mean that different holes sizes must be drilled to accommodate for
plating?

Sincerely,

Roger Mouton

EIMC - Advanced Plating Technologies
949 481-5194
www.smartcatshield.com
[log in to unmask]


Notice of Confidentiality
The information contained in and transmitted with this email may be
confidential and is intended only for the individual or entity named above.
If you are not the intended recipient, you are hereby notified that
inadvertent disclosure of this information to you does not constitute a
waiver of confidentiality privilege and that any review, disclosure,
copying, or use of the contents of the email by you is prohibited.

---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------