Is there any spec. on drilling a plated hole non-plated hole form the edge,
I mean, what is the safest minimum distance a hole can be drilled from the
edge. I believe thickness of the board is a one factor.
Re,
Ken Patel
______________________________________________________
Ken Patel Phone: (408) 490-6804
575 Cottonwood Dr. Fax: (408) 490-6859
Milpitas, CA 95035 Beeper: (888) 769-1808
##############################################################
TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c
##############################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE TECHNET <your full name>
To unsubscribe: SIGNOFF TECHNET
##############################################################
Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information.
For the technical support contact Dmitriy Sklyar at [log in to unmask] or 847-509-9700 ext.311
##############################################################