Hi all,
Anybody that have experience from wave soldering of 12 layer boards, six
power and ground planes, thickness of 2,3 mm populated with through hole
connectors and ceramic pin grid arrays.
I know there is a pin-hole relationship but does the thickness also come in
as a parameter? Can it be critical with temperature so I achieve reflow of
solder joint on the component side and or destroy the board?
Thanks for your comments
Hans Bogren
Ericsson Telecom
)
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************