Sender: |
|
X-To: |
|
Date: |
Tue, 21 May 2013 16:12:30 +0000 |
Reply-To: |
|
Message-ID: |
|
Subject: |
|
From: |
|
MIME-Version: |
1.0 |
In-Reply-To: |
|
Content-Transfer-Encoding: |
quoted-printable |
Content-Type: |
text/plain; charset="us-ascii" |
Parts/Attachments: |
|
|
Or reduce the amount of flux going into the system. Overspraying or excessive flux drag-out can lead to the foaming.
Sometimes if excessive rework is being done with a lot of tacky flux, etc, you will encounter foaming.
-----Original Message-----
From: TechNet [mailto:[log in to unmask]] On Behalf Of Steve Gregory
Sent: Tuesday, May 21, 2013 10:02 AM
To: [log in to unmask]
Subject: [TN] Another Closed-loop cleaner question...
Morning all,
I may have already asked this once, and I think I know the answer, but I'll ask anyway.
It's not a good idea to use defoamers in a closed-loop cleaner, right?
If we're getting too much foam in the wash tank, we should add another carbon bed, correct?
Thanks to any who reply,
Steve Gregory
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask] ______________________________________________________________________
______________________________________________________________________
This email has been scanned by the Symantec Email Security.cloud service.
For more information please contact helpdesk at x2960 or [log in to unmask]
______________________________________________________________________
|
|
|