 
| Subject: | |
| From: | |
| Date: | Thu, 12 Dec 1996 23:44:32 -0500 |
| Content-Type: | text/plain |
| Parts/Attachments: |
|
|
The original spec was put in by the military to eliminate "punch through."
This happens in the Z direction in thin cores and thick (large tooth) copper.
With new copper (low profile) techniques, this should not be a problem. I'd
worry only with very thin core and thick large tooth copper. The cost
advantage is obvious.
J S Sallo Sallo Consulting Services
Phone or fax 619 346 6717
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
* If you are having a problem with the IPC TechNet forum please contact *
* Dmitriy Sklyar at 847-509-9700 ext. 311 or email at [log in to unmask] *
***************************************************************************
|
|
|
