Hi KennyB,
I think you guessed correctly.
The problem with Pb-free soldering is that all your caps are jeopardized to a
larger extent than with SnPb. With some you get away with it, with others
just another little nudge causes failure.
That large plated-through hole and connector stud are likely to have a
somewhat higher CTE(x,y) than your PCB—voila.
My recommendation is to reduce all cap pads, and RRs as well, to half the cap
widths to reduce the size of the solder fillet 'vise grips.' Those pad widths
were needed for wave soldering and the fillets for inspection.
Werner
**************
Need a new ride? Check out the largest site for U.S. used car
listings at AOL Autos.
(http://autos.aol.com/used?NCID=aolcmp00300000002851)
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 15.0
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
-----------------------------------------------------