Hi Bev:
Just to put my two cents in, you are asking a question that is difficult to
apply to all circumstances. Involved would be size of part, type of part,
type of flux, wetting angle of cleaning solution etc. However, in my
experience, a good place to start an evaluation of your conditions would be
in the range of 15 to 20 mils standoff. Hope this helps.
Larry
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/html/forum.htm for additional
information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------