 
| Received: |
by ipc.org (Smail3.1.28.1 #2)
id m0vMA6c-0000RYC; Sat, 9 Nov 96 03:53 CST |
| Old-Return-Path: |
|
| From [log in to unmask] Thu Nov 14 10: |
45:51 1996 |
| Precedence: |
list |
| Resent-From: |
|
| Resent-Sender: |
|
| X-Status: |
|
| Status: |
O |
| X-Mailing-List: |
|
| TO: |
|
| Return-Path: |
<TechNet-request> |
| Resent-Message-ID: |
<"vVOn61.0.wc3.XI5Xo"@ipc> |
| Subject: |
|
| From: |
|
| Message-ID: |
|
| X-Loop: |
|
| Date: |
09 Nov 96 05:01:30 EST |
| Parts/Attachments: |
|
|
Check your product liability insurance first. This would be a low reliability
assembly:
Even if you could get it to wet and you could remove the very active flux
residues TOTALLY you are still faced with the prospect of two very dissimilar
metals in intimate contact and carrying current so some type of protective
coating would be advisable.
Mike Fenner
BSP
--------------------------
From: John Parsons <[log in to unmask]>
> Date: Thu, 7 Nov 1996 14:43:33 -0800
> Subject: ASSY: Aluminum to Tin/Lead
> To: IPC TechNet <[log in to unmask]>
>
> We are quoting on a job for which we have been provided very little
> information. We do know that a 0.030 aluminum wire must be "soldered" to a
> trace on the board. We are told that the finish "looks" like tin/lead.
>
> My question, is it possible to solder an aluminum wire to tin/lead, and if
> "YES" using what type of solder. If "NO" what is the likely finish on this
> board.
>
> Thanks
***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
***************************************************************************
|
|
|
