My question to fellow TechNetters is:

What are some typical Ionic Contamination Levels seen at Pre-Soldermask
application and Final levels of bare board before shipping?

Do other end users require monitoring of Pre-Soldermask levels of Ionic
Contamination or just at final?

We are currently going to specify 10 micro grams/sq" does anyone else
specify anything tighter? Is there a cost associated at the boasrd level
to spec something tighter.

Steve Collins
PCB Design Supervisor
TSX Corporation
El Paso, TX
Ph: (800) 351-2345
Fax: (915) 543-4898
email: [log in to unmask]

***************************************************************************
* TechNet mail list is provided as a service by IPC using SmartList v3.05 *
***************************************************************************
* To unsubscribe from this list at any time, send a message to:           *
* [log in to unmask] with <subject: unsubscribe> and no text.        *
***************************************************************************