Subject: | |
From: | |
Reply To: | TechNet E-Mail Forum. |
Date: | Mon, 20 Oct 2003 11:17:32 -0400 |
Content-Type: | multipart/alternative |
Parts/Attachments: |
|
|
Jim,
There is an IPC committee working on 4 point bend testing. I can't remember the number. It started out as an off-line project by Celestica/Cisco/Intel/Sun. There is a draft doc, but I did not make the committee meeting in Minneapolis, so I do not know where they are at. For c, I would ask the JEDEC crowd.
Bev Christian
Research in Motion
-----Original Message-----
From: Jim Reed [mailto:[log in to unmask]]
Sent: October 20, 2003 10:52 AM
To: [log in to unmask]
Subject: [TN] Mechanical Reliability Test Methods
A little help with Specifications please...
Are there any sort of industry standards which define the following tests:
a. three point bend test
b. four point bend test
c. ball shear test
d. board level torsion test
I am aware of a number of internal documents at several companies for many of these. The question is: Are there any published tests that concern themselves with these kinds of tests, such as IPC, ISO, MIL, ASTM, etc.?
Jim Reed, Global Commodity Quality Mgr.
Dell
Phone: (512) 723-5083
Fax: (512) 783-6161
Email: [log in to unmask]
---------------------------------------------------
Technet Mail List provided as a free service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
---------------------------------------------------
Technet Mail List provided as a service by IPC using LISTSERV 1.8e
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF Technet
To temporarily halt or (re-start) delivery of Technet send e-mail to [log in to unmask]: SET Technet NOMAIL or (MAIL)
To receive ONE mailing per day of all the posts: send e-mail to [log in to unmask]: SET Technet Digest
Search the archives of previous posts at: http://listserv.ipc.org/archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-509-9700 ext.5315
-----------------------------------------------------
|
|
|