George,
   I don't know of any converters that will work 100% form one tool to
another. Someone else may have some better information on that. The way we
have done this is basically re-enter the schematics. We currently don't have
the NT version of Mentor running however from what I understand, UNIX or NT
in Mentor seem to go back and forth ok. If you can't find anything to do the
job for you, give me a call or drop a line and maybe we can help. BTW, why
are you converting? Is the company moving to Mentor?
Later...

Regards,
Scott Decker

AKA: PadMasterson
Mentor Design, Phoenix
4500 S. Lakeshore Dr., Suite 339, Tempe, AZ 85282
(480) 730-2600 ext. 284 FAX: (480) 730-2640
[log in to unmask] <mailto:[log in to unmask]>
Web site: www.e2ecorp.com <http://www.e2ecorp.com>

e2E  Corporation
Reducing Time to Market & Enabling Knowledge





        -----Original Message-----
        From:   Kotecki, George [SMTP:[log in to unmask]]
        Sent:   Wednesday, May 31, 2000 7:34 AM
        To:     [log in to unmask]
        Subject:        [DC] Cadence to Mentor

        Does anyone out there know where I can get information regarding
switching
        from Cadence Concept/Allegro on NT to equivalent Mentor products
also on NT?
        What I am looking for are issues to be concerned about, ease of
legacy
        translation, etc.  Please e-mail off-line to avoid any vendor
bashing or
        advertising.  Thanks in advance.

        George Kotecki