Subject: | |
From: | |
Reply To: | (Designers Council Forum) |
Date: | Wed, 12 Mar 2008 07:27:29 -0500 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
Hi Scott-
Check out IPC-CM-770. Or (better idea), try to get the manuals for the
insertion equipment to be used, if any.
Hole sizing is somewhat dependent on insertion method (hand vs. machine).
Keepout areas/courtyard is very dependent on insertion equipment to be
used. Watch out for clinch/cut on bottom side.
Lead span for axial parts... see above...
Component orientations very restricted by combination of equipment and
tape-and-reel orientation for radial (stand-up) parts.
Feel like you're working with a stone tablet and a chisel?
Best Regards,
-Chris
Scott Riley <[log in to unmask]>
Sent by: DesignerCouncil <[log in to unmask]>
03/12/2008 06:45 AM
Please respond to
"(Designers Council Forum)" <[log in to unmask]>; Please respond to
Scott Riley <[log in to unmask]>
To
[log in to unmask]
cc
Subject
[DC] Through-hole component standards
I'm working on a large power board that uses all through-hole parts..lots
of
them. Is there anything for through-hole parts that would be similar to
IP-7351 ? I've searched the IPC standards and PCB Libraries site and
others, but haven't found much for through-components.
I'm using the data sheets, but for the most part they don't have anything
regarding the recommended PCB hole sizes or mechanical/electrical
clearances
(courtyard). Can anyone point me someplace where I might be able to find
some additional information ?
Scott D. Riley
Technical Design Service
607-658-9322 - Office
607-785-1696 - FAX
<http://www.techdesignservice.com> www.techdesignservice.com
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV
1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET
DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases >
E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16
for additional information, or contact Keach Sasamori at [log in to unmask] or
847-615-7100 ext.2815
---------------------------------------------------------------------------------
"This e-mail message is intended only for the use of the intended
recipient(s).
The information contained therein may be confidential or privileged, and
its disclosure or reproduction is strictly prohibited.
If you are not the intended recipient, please return it immediately to its
sender at the above address and destroy it."
---------------------------------------------------------------------------------
DesignerCouncil Mail List provided as a free service by IPC using LISTSERV 1.8d
To unsubscribe, send a message to [log in to unmask] with following text in
the BODY (NOT the subject field): SIGNOFF DesignerCouncil.
To temporarily stop/(restart) delivery of DesignerCouncil send: SET DesignerCouncil NOMAIL/(MAIL)
Search previous postings at: www.ipc.org > On-Line Resources & Databases > E-mail Archives
Please visit IPC web site http://www.ipc.org/contentpage.asp?Pageid=4.3.16 for additional information, or contact Keach Sasamori at [log in to unmask] or 847-615-7100 ext.2815
---------------------------------------------------------------------------------
|
|
|