Juan...
We use the same tooling hole parameters for all
products. The holes are located with respect to each
other with a tolerence of +/- .003 and the finished
non-plated hole tolerence is +/- .001. Works for us.
Hope this helps.
Regards,
Bob Vanech
****************************************************************************
* The mail list is provided as a service by IPC using SmartList v3.05 *
****************************************************************************
* To unsubscribe from this list at any time, send a message to: *
* [log in to unmask] with <subject: unsubscribe> and no text. *
****************************************************************************