Subject: | |
From: | |
Reply To: | DesignerCouncil E-Mail Forum. |
Date: | Fri, 26 Feb 1999 09:36:03 -0000 |
Content-Type: | text/plain |
Parts/Attachments: |
|
|
-----Original Message-----
From: Mary Sugden <[log in to unmask]>
To: [log in to unmask] <[log in to unmask]>
Date: 26 February 1999 00:04
Subject: [DC] PowerLogic & Resistor Packs??
>I Have run into a problem in creating meaningful symbols for resistor packs
in
>PowerLogic. Showing all resistors together as one symbol is not a problem.
>However, ther are many instances where individual resitors within a pack
are
>scattered all over the schematic and a single symbol is not practical. I
have
>tried everything that I can think of to draw and package individual
resistors
>within a pack that be be used separately, so that I do not get error
reports
>on the netlist or problems when impoting the netlist into PCB. I also need
an
>intelligent database in order to run circuit simulation routines. Does
anyone
>have an answer or workaround for me.
>
>Thank,
>Helpless in Silicon Valley
>[log in to unmask]
>
>################################################################
>DesignerCouncil E-Mail Forum provided as a free service by IPC using
LISTSERV 1.8c
>################################################################
>To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
>To subscribe: SUBSCRIBE DesignerCouncil <your full name>
>To unsubscribe: SIGNOFF DesignerCouncil
>################################################################
>Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
>For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
>################################################################
>
>
Melinda,
The way that I have got around this problem is to draw the individual
resistors with just one electrical pin per gate. I then added a dummy pin
one with lines and text. Then I assigned pin 1 in "Signal Pin" in the gate
editor as
+5V or GND etc.
I will send to your email address [log in to unmask]
a logic diagram with some resistors, feel free to merge them
into your library.
Regards
Robert ( London )
################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe: SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe: SIGNOFF DesignerCouncil
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################
|
|
|