-----Original Message----- From: Mary Sugden <[log in to unmask]> To: [log in to unmask] <[log in to unmask]> Date: 26 February 1999 00:04 Subject: [DC] PowerLogic & Resistor Packs?? >I Have run into a problem in creating meaningful symbols for resistor packs in >PowerLogic. Showing all resistors together as one symbol is not a problem. >However, ther are many instances where individual resitors within a pack are >scattered all over the schematic and a single symbol is not practical. I have >tried everything that I can think of to draw and package individual resistors >within a pack that be be used separately, so that I do not get error reports >on the netlist or problems when impoting the netlist into PCB. I also need an >intelligent database in order to run circuit simulation routines. Does anyone >have an answer or workaround for me. > >Thank, >Helpless in Silicon Valley >[log in to unmask] > >################################################################ >DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c >################################################################ >To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: >To subscribe: SUBSCRIBE DesignerCouncil <your full name> >To unsubscribe: SIGNOFF DesignerCouncil >################################################################ >Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. >For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 >################################################################ > > Melinda, The way that I have got around this problem is to draw the individual resistors with just one electrical pin per gate. I then added a dummy pin one with lines and text. Then I assigned pin 1 in "Signal Pin" in the gate editor as +5V or GND etc. I will send to your email address [log in to unmask] a logic diagram with some resistors, feel free to merge them into your library. Regards Robert ( London ) ################################################################ DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE DesignerCouncil <your full name> To unsubscribe: SIGNOFF DesignerCouncil ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################