Ken, .050 should be enough.. William Sullivan C.I.D Supervisor Printed Circuit Board Design > ---------- > From: Ken Patel[SMTP:[log in to unmask]] > Reply To: TechNet E-Mail Forum.;Ken Patel > Sent: Thursday, December 09, 1999 4:13 PM > To: [log in to unmask] > Subject: [TN] Edge Clearance for power & ground planes > > Guys, > How far my power & ground planes should be away from the egge of the > board? > > re, > ken patel > ______________________________________________________ > Ken Patel Phone: (408) 490-6804 > 1708 McCarthy Blvd. Fax: (408) 490-6859 > Milpitas, CA 95035 Beeper: (888) 769-1808 > > ############################################################## > TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c > ############################################################## > To subscribe/unsubscribe, send a message to [log in to unmask] with > following text in > the body: > To subscribe: SUBSCRIBE TECHNET <your full name> > To unsubscribe: SIGNOFF TECHNET > ############################################################## > Please visit IPC web site (http://www.ipc.org/html/forum.htm) for > additional > information. > If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or > 847-509-9700 ext.5365 > ############################################################## > ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################