Can anyone with fab CAM expertise tell me if there is a typical SIZE for the vendor logo? Is there a maximum size? We prefer them in copper on the back of the board, but sometimes we need to make a little relief in a plane (cut out a rectangle) for the logo. The question is: How big should the relief or rectangle be? Thanks in advance, Jack ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################