Greetings, We are in the process of setting up our first high volume pin in hole reflow process. We have a fairly large blade on the header, with a large hole on the PCB. We seem to be forcing paste through the hole and it hangs out the bottom. Does anyone have any suggestions about stencil aperture dimensions and shields so that we don't force solder paste out the bottom of the PCB and make a mess of our tooling. Thanks, Aric Parr Sr. Process Engineer Eaton Corporation 1400 S. Livernois PO Box 5020 Rochester Hills, MI 48308-5020 248 608 7780 [log in to unmask] ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################