In a message dated 09/03/1999 1:01:58 PM Central Daylight Time, [log in to unmask] writes: << Does anyone know where I can get a mini (table-top) drill press with precision location in XYZ? I used to have one for drilling out PTH in multi-layer PCB's for design changes/verifications/prototypes. I would like to have .001" accuracy in all three axes. Jon Moore >> Hi Jon! I think you're looking for something a little more sophisticated than a "Dremel" drill huh? If you go to: http://www.t-tech.com/ , they have the kind of machines that meets your accuracy specs. They have a machine called "Proto Drill", and another called "Quick Circuit" which is a combination drill/router. The Proto Drill can do holes as small as .008", and the Quick Circuit can do .013". Both are accurate to .001"...you're looking at around $20,000 or so...not cheap! -Steve Gregory- ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################