All polymer based materials have a maximum temperature to which they can be exposed before they start to breakdown. THis temperatue will vary from polymer to polymer and is also subject to being modified by conditions of exposure and other materials present. For example it will be lower in oxygen rich environments.This breakdown is cumulative and irreversible. Think of it as invisible charring to understand its effects. The adhesive properties of charcoal are not usually regarded as outstanding. As a general rule you would not expect "Acrylate" adhesives to have good high temperatue withstand, high in this context would certainly include the temperatures expected during pcb assembly processes,and acrylates are generally not as good as epoxies which usually have a max continuous rating in the 150C - 200C max range. However the problem with adhesives and general rules is that there is a huge number of proprietary formulations and the candidate materials that the suppliers can use as bases for their blends is also large, notwithstanding the combinations in their final blends. So the first thing to do is read the data sheet on your particular one as if you were a lawyer. See just what is specifically stated on performance and not what the words leave you to expect. Match the minimum specifications expected in this way with what you actually anticipate the most severe in-service environment (including heat, moisture, mechanical stress, chemical exposure etc) will be to form an opinion as to suitability. Do the same for your processing options and limitations imposed by substrates to be joined. Then from the range of candidate products you can narrow down your choice based on ease of use, availability and so on. You may or may not end up with an acrylic based material. Mike Fenner BSP, OX15 4JQ, England T:+44 1295 722 992 F: +44 1295 720 937 -----Original Message----- From: Matthew Sanders <[log in to unmask]> To: [log in to unmask] <[log in to unmask]> Date: 01 July 1999 21:30 Subject: [TN] Acrylic adhesive resistance to temp >Hello all, > >Thanks to all, by the way, for help on my last delamination problem on flex >circuits - we think we've licked it. Here's my next question: > >I'm wondering about the degradation of performance of acrylic adhesives with >exposure to temperature. I think I've seen a lot of people mention that the >adhesive becomes brittle over time at exposure to heat. Does anyone have any >data they can share? Also, are there other properties that are affected? >Does the bond strength suffer? > >Thanks for any info! >Matt Sanders > >Matthew Sanders >PCB/Metal Procurement Engineer, Trimble Navigation Ltd. >[log in to unmask] >Phone: (408) 481-7817 >Fax: (408) 481-8590 >