Charlie: Typically pre-baking is done prior to assembly. The recommended temperature is 250F for 2 hours. We also recommend running a dummy sample through the reflow process with thermocouple to make sure that the profile is set correctly for rigid-flex (it is a little different than typical rigid boards). This will also flag if the boards still have moisture (sometimes it has taken over 12 hours to completely rid the boards of moisture). You can reach me at Flex Interconnect Technologies - 408-288-8625 if you need further information. Chetan >From: Charles Barker <[log in to unmask]> >Reply-To: "TechNet E-Mail Forum." <[log in to unmask]>, [log in to unmask] >To: [log in to unmask] >Subject: [TN] Board baking >Date: Sun, 18 Jul 1999 13:53:23 -0500 > >We are just getting into regular assembly of rigid-flex boards. What are >folks doing about removing the moisture absorbed in the flex? > >Is anyone using nitrogen as a drying agent? What are sources of >"dry-boxes" and such? > >All you flex makers out there, what do you recommend? > >TIA > >Charlie Barker > >############################################################## >TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c >############################################################## >To subscribe/unsubscribe, send a message to [log in to unmask] with following >text in >the body: >To subscribe: SUBSCRIBE TECHNET <your full name> >To unsubscribe: SIGNOFF TECHNET >############################################################## >Please visit IPC web site (http://www.ipc.org/html/forum.htm) for >additional >information. >If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or >847-509-9700 ext.5365 >############################################################## _______________________________________________________________ Get Free Email and Do More On The Web. Visit http://www.msn.com ############################################################## TechNet Mail List provided as a free service by IPC using LISTSERV 1.8c ############################################################## To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TECHNET <your full name> To unsubscribe: SIGNOFF TECHNET ############################################################## Please visit IPC web site (http://www.ipc.org/html/forum.htm) for additional information. If you need assistance - contact Gayatri Sardeshpande at [log in to unmask] or 847-509-9700 ext.5365 ##############################################################