Hello all,

I am sure this one will stretch the memory!! I used to know the specifics,
but when you don't use something, well, it kinda goes away!

We have a hole position tolerance of .009"TP (True Position). Can anyone
tell me how to convert this tolerance into an X-Y location value? Like,
based on the zero datum you are allowed a maximum of .003" x .003" off the
defined location. Or, you are allowed a maximum of .006" in any direction
combination which represents the .009"TP.

The only number I am using from actual is the .009"TP. Taking that tolerance
and defining the location values allowed is what I am having a tough time
finding out.

Thanks to anyone who can save me here!

Richard Hamilton
Clemar Mfg. / Rain Bird
[log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################