Technetters, Our design engineers are insisting on putting a wire for a current loop on one of our boards. Is their a faster, cheaper way to achieve the same result? This wire assembly is going to slow down and make expensive a board which is currently all surface mount. Thanks in advance. -Steve Steven K. Lustig Process Engineer EMS Technologies, Inc. Norcross, GA (770) 263-9200 x4714 [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################