Hi techies,

  I received a board sample that probably we could assembly here, but I had
one doubt about the manufacturing process.
  The board is a VGA card and has trough hole and SMD components at top side
and 2 QFP 100 at bottom side. The 2 QFP had no glue attaching the components
and were not soldered by solder wave machine, but all trough hole components
were soldered.
  The question is :
  The 2 QFP were covered with solder mask and passed to the solder wave
machine ? Or they used selective solder to avoid contact with the 2 QFP ? Or
there are other ways to assembly this kind of board ?
   I am trying to figure out how they assembly this board, I am not familiar
with this kind of assembly.
   Any input will be apreciated.

Thanks

Jorge Dourado de Santana
Maintenance / Process Engr
Microtec - Brazil

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################