Rudolph Try KJ Marketing, I have an ad from them about an "inspection overlay" that sounds like what you are looking for. http://www.kjmarketing.com/PRODUCF.HTM <http://www.kjmarketing.com/PRODUCF.HTM> Similar to the transparent "kepoch" stencils they make, they will put cut-outs wherever you should have a part - so you drop it over the board and look for empty holes... Haven't tried one, so I can't advise as to it's success but it sounds like a good plan. regards, Graham Collins Process Engineer, Litton Systems Canada, Atlantic Facility (902) 873-2000 ext 6215 -----Original Message----- From: Yu, Rudolph [mailto:[log in to unmask]] Sent: Wednesday, June 09, 1999 8:27 PM To: [log in to unmask] Subject: [TN] Conductive Transparency Can anyone tell me if there is any ESD/Conductive transparencies in the Market currently? I am thinking to use it for the first article inspection on the high count passive components. Any ideas? Thanks. ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################