I use a glue dispensor, double up on the dots. Joe At 03:54 PM 6/9/99 +0200, you wrote: >We have a simple board in which we are using our screen printer to apply >reflow curing glue, in between the pads, etc. > >The chipshooter components 0603, sots, etc do perfectly. > >The IC's and any other part with a gull wing, J wing type do not have >enough glue to even touch the bottom of the parts. Because as you know, the >body sits off the board > >Step stencil comes to mind but never done that YET. Using rubber squeegees >on printer. Tried putting in a big snapoff where it would leave a space >between the pcb and stencil but this helps but not a cure. Any suggestions. > >Step stencil, stencil thickness. Did not put what thickness of what stencil >we use to see what you all have to say. > >Thanks in advance. > >John > >################################################################ >TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c >################################################################ >To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: >To subscribe: SUBSCRIBE TechNet <your full name> >To unsubscribe: SIGNOFF TechNet >################################################################ >Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. >For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 >################################################################ > Joe Wackerman Sr. Mechanical Engineer Parker Hannifin Compumotor Division 5500 Business Park Drive Rohnert Park, CA 94928 http://www.compumotor.com voice 707-584-2522 FAX 707-584-8015 e-mail [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################