Hello Technetters, The helpful correspondence on Gerber to dot.PDF has prompted me to ask if you can suggest how to convert from AutoCAD to dot.PDF The AutoCAD we run (ver 14) can output to dot.EPS, but not to dot.PS Our Distiller takes in dot.PS but not dot.EPS Do you know how to make the conversion we need? I would appreciate any information on means of getting from AutoCAD to dot.PDF Many thanks, Tom ____________________________________________________________________ Get free e-mail and a permanent address at http://www.netaddress.com/?N=1 ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################ ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################