Hey Steve,
Mind sending me a copy too?

-----Original Message-----
From: Stephen R. Gregory [mailto:[log in to unmask]]
Sent: Thursday, May 27, 1999 1:09 AM
To: [log in to unmask]
Subject: Re: [TN] Plated Through-Hole


In a message dated 5/26/99 5:27:45 AM Pacific Daylight Time,
[log in to unmask] writes:

<< Steve,
 I hope you don't my asking this, but, I'm going to anyway.
 When you say, "and since there's no pad on the bottom, and the barrel isn't
 plated....VIOLA'! No masking and no filled tooling hole!"

 I understand that the barrel is copper, is this true? Even without a pad
 on the solder side, I've had solder wick up the barrel.
 I'm not sure I totally understand your process, and since I've had
 problems with this before, I'd REALLY like to understand.

 Allen Maddox >>

Hi Allen!

Actually, there's NO COPPER plated in the barrel...so no solder fills it
during wave. To make things easier to explain, I'll just send you a couple
of
pictures of what these "UFO tooling holes" look like. Just so happens I have
a board here that has them incorporated in it , and I've got my cool new
digital camera with me, and I'll send ya' a view of what the top and bottom
looks like. I'm zipping them up and sending em' to ya' in *.JPG format. A
picture is worth a thousand words as they say....

-Steve Gregory-

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following
text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section
for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or
847-509-9700 ext.312
################################################################

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################