Dear Technetters Has anyone heard about something called side braze DIP or bottom brazed DIP? What does it mean? Is there a physical difference in the size between a plastic DIP and a ceramic DIP, i.e. is there a difference in the footprint. -- Best Regards ``` Khaled H. Fouad (o o) ==============================================oOO--(_)--OOo============ Senior PCB Designer Research & Development Department International Electrical Products Member of BAHGAT Group Second Industrial Zone, Plot 240 6 October City, Egypt Tel. : +20 (11) 333414-9 Ext. : 312 Mobile : 010 140 5324 Fax. : +20 (11) 335613 (Direct) +20 (11) 333420 WWW : http://www.bahgat.com Email : [log in to unmask] ======================================================================= ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################