Greetings,

For all the SMT assemblers out there, what are your average fall out on
std. components, ie. 1206, 1210, 2010, sot-23, melf, minimelf.
I have 2 mydata machines and they run well under 2%. I wonder if 2% or
less than 2% fall-out is too high.

Thanks in advance for any input.

Dewey
Get Your Private, Free Email at http://www.hotmail.com

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################