Tech-Netters: Anyone out there wave soldering CWR06 tantalum caps? Our design group has populated some of the larger case sizes on the back side of some boards. I didn't like this for a couple of reasons. #1 - The large case size will produce problems with "shadowing" since I do not have a chip wave. #2 - I didn't think that tantalum caps would survive the 500 degree F plunge into the wave. Any comments on wavesoldering these parts? Any and all responses are welcome. Thanks, Bill Kasprzak Moog Inc. ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################