Hi Techies! I am getting slivers off the edges of gold fingers on the PCB edge connector. These slivers appear when the board is inserted into a standard PC system. Any background available on your experiences (cause, solutions containment activities/screens, etc.) would be appreciated. Thanks & regards, > Bill Davis, Ph.D. > Diamond Multimedia Systems > Senior Scientist > Tel. 408.325.7868 > Cell. 408.888.5650 > e-mail: [log in to unmask] > > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################