In reviewing IPC-600 on burrs in holes I can only find information
pertaining to plated through holes.

I have a condition where there is a non-plated hole (pad on one side
only) that has burring on it.  This should be considered, I believe, as an
unsupported hole, yet the only examination of this type of hole is for
haloing (2.6.1)

Is there any other location in any spec that specifies the acceptable
requirements for this type of hole?

Thank you for any responses.

Larry Campbell
BFGoodrich, Avionics Systems

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################