We have the wonderful challenge of ramping up quickly to build rigid-flex assemblies in the 1,000 to 6,000 per month quantities. Serious concerns are the proper handling, testing, and de-paneling. I looked in the archives, but didn't see specific suggestions in these areas. (I may have missed them if they are there.) Is there a router/depaneler out there that is good at depanelling R-F assemblies with parts on both sides, including up to 1/2" long swaged standoffs? TIA Charlie Barker Input/Output, Inc. 281-552-3328 Voice 281-552-3100 FAX [log in to unmask] ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################