John, Have you tried Equipto? They can be reached at 708 897-4691. They manufacture rack systems and can often customize per your requirements. Good luck! Chad Thibodeau Component Engineer [log in to unmask] 2114 W. 7th Street Tempe, AZ 85281 P-602 333-2138 F-602 921-9012 http://www.efdata.com > -----Original Message----- > From: John Lennox [SMTP:[log in to unmask]] > Sent: Wednesday, January 13, 1999 3:39 PM > To: [log in to unmask] > Subject: [TN] Fab: Panel Racks > > TechNet: > > I am looking for a source of racks for bare boards up to a panel size of > 18"x24". > They need to hold the panels horizontally and be small enough for one > person to lift them into an oven. Ideally, they would hold between 15 and > 20 panels. > > I have seen some larger horizontal racks that have spring hinges on one > side, where the operator initially lifts all of the racks, and begins > filling from the bottom - flipping down the next rack as they go. > This system would be ideal if it was small enough to be lifted. > > Any sources of information would be appreciated. > > Thanks, > John Lennox > EMC > > ################################################################ > TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c > ################################################################ > To subscribe/unsubscribe, send a message to [log in to unmask] with > following text in the body: > To subscribe: SUBSCRIBE TechNet <your full name> > To unsubscribe: SIGNOFF TechNet > ################################################################ > Please visit IPC's web site (http://www.ipc.org) "On-Line Services" > section for additional information. > For technical support contact Hugo Scaramuzza at [log in to unmask] or > 847-509-9700 ext.312 > ################################################################ ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################