You can try Bob Willis at [log in to unmask] (website www.bobwillis.co.uk) - not there till Thursday though or TWI Welding institute microtechnology dept at [log in to unmask] (website www.twi.co.uk). Bob is a pcba manufacturing expert and a well known guru in this field. TWI cover a broad spectrum but do offer Xray and sectioning of vias. I am currently using both for my own purposes. Bob Gallagher -----Original Message----- From: Burtt, Nigel [mailto:[log in to unmask]] Sent: 01 December, 1998 12:03 PM To: [log in to unmask] Subject: [TN] PCB micro-sectioning Would anyone care to recommend an independent PCB micro-sectioning service in the UK for some studies we are carrying out on plating failures in small via holes. > Nigel Burtt > Production Engineering Manager > D - European HQ > Email: [log in to unmask] > Tel: 01793 842132 > Fax: 01793 842101 > > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################