Hi Technetters!

Just as we check the viscosity of solder paste (before printing) and check
for the printed paste height on the PWB (after printing), does anybody go
for similar exercises in case of Glue printing?

If yes, pls. suggest.


Vinit Verma
Ph: 0124 372721,2,3(O)  Fax: 0124 372724 (O)
    011 7871747 (R)          011 5783571 (R)

--------------------------------------------------------------
Bharti Telecom Limited, Gurgaon, India

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################