I'll jump on that bandwagon too - I'd also like a copy of the paper (apparently everybody wants a copy of this paper - maybe it would be just be easiest, if legal, to just post the paper on technet or on a web page where everyone can access it and stopp clogging technet). Brett Goldstein EVI, Inc. [log in to unmask] > I would also like to receive a copy of this paper, please. > > Tom Moss > [log in to unmask] > > > ______________________________ Reply Separator > _________________________________ > Subject: Re: [TN] Re[2]: [TN] Re[2]: [TN] PCB ASSEMBLY COST ANALYSIS > Author: "Gus Morvillo" [SMTP:[log in to unmask]] at MSXGATE > Date: 10/27/98 8:08 AM > > > Please forward me a copy of this paper, as well > Gus Morvillo > [log in to unmask] > > [log in to unmask] wrote: > > > this paper "could" be very helpful, please forward a copy to my > > attention as well. > > > > Ron Frye, HADCO > > [log in to unmask] > > > > ______________________________ Reply Separator > > > > > > > > > -----Original Message----- > > > > > From: [log in to unmask] [SMTP:[log in to unmask]] > > > > > Sent: 23 October 1998 01:00 > > > > > To: [log in to unmask] > > > > > Subject: Re: [TN] PCB ASSEMBLY COST ANALYSIS > > > > > > > > > > *** WARNING *** > > > > > > > > > > This mail has originated outside your organization, > > > > > either from an external partner or the Global Internet. > > > > > Keep this in mind if you answer this message. > > > > > > > > > > > > > > > Dave and all - > > > > > I have been working with some associates on developing some > > > > > Cost Estimation > > > > > software for assembly. Contact me off-Technet for more > > > > > information. I will > > > > > be giving a paper on the subject at the IPC/SMTA wingding > > > in > > > > > Providence on > > > > > Wed. > > > > > Regards, > > > > > Phil Zarrow > > > > > ITM, Inc. > > > > > [log in to unmask] > > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################