TechNet, I am looking for a specification for rework, specifically, a lifted lead of a component that will then get a jumper wire attached. I haven't found anything that really seems to address this situation in IPC-610, IPC-700 or JSTD-001. Is there another spec I need to look at, is this not acceptable to IPC, or have I just missed it in one of these manuals?? Any assistance or opinion appreciated. Tks........DT ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################