At 01:09 PM 10/27/98 -0500, Chris Ball wrote:
>Hi Doug,
>
>>          Component Side
>>
>>             trace
>>S1    IC#1 --->---+    +-->-IC#2
>>Gnd  ---------<---|----|--<-----
>>Pwr  ??? ---------|--<-|---- ???
>>S2   -------------+-->-+--------
>>
>>          Solder Side
>
>So what's a better way? Another ground layer between Pwr and S2? Please
>elaborate when you have the time.

Well, yes ---> if it's allowed <---.
Then, sock the ground planes down to
one another with plenty of connections.

My personal preference to start *any* stack up with

 Gnd  ----------------
 Pwr  ----------------
 Gnd  ----------------

as a cornerstone for the entire board layout.
Then add extra signal and ground layers above
and below this structure.

*** This is obviously not a hard fast rule. I.e. what's
    the cost differential between a 4 and 5 layer board,
    or between a 6 and 7 layer board?
    <I ask rhetorically sort of chuckling ...>

################################################################
DesignerCouncil E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE DesignerCouncil <your full name>
To unsubscribe:   SIGNOFF DesignerCouncil 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################