Darrel--

There aren't any real hard design requirements, though some regulatory groups have electrical spacing
requirements.

As a start, use the IPC-D-275/IPC-2221, electrical spacing requirements from the "A" columns.

Most electronic packaging has a minimum electrical spacing requirement depending on worst case analysis.

Don't forget to allow for the printed board, cover of "chassis plate" to "flex" due to mechanical shock or
vibration.

Ralph

Darrel Therriault wrote:

> Designers,
>
> We have a midplane attached to a metal chassis.  There are some vias that
> appear to be very close to the chassis and I was wondering what the
> guideline is for spacing from any via/etch/signal to chassis might be.
> While I am busy looking through the IPC design rules, I thought I'd throw
> it out on Technet to see what other opinions and guidelines might be shared.
>
> Thanks in advance.....DT
>
> ################################################################
> TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
> ################################################################
> To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
> To subscribe:   SUBSCRIBE TechNet <your full name>
> To unsubscribe:   SIGNOFF TechNet
> ################################################################
> Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
> For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
> ################################################################



--
Ralph Hersey

Ralph Hersey & Associates
3885 Mills Way
Livermore, CA 94550-3319
PHN/FAX: 925.454.9805
e-mail: [log in to unmask]

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################