We typically receive no cost reduction from the PWB manufacturers for switching from HASL to OSP or vice versa. This applies in a general case. If there is a particular advantage to the supplier to get away from solder (say you have a very stringent requirement of no solder on the gold contacts of a board) then you may get cost advantages in isolated cases. In the case of the assembly house, it depends. It depends on how much better your yields get with the advantages (flat solderable surfaces) of the OSP. Or how much worse your yields get with the OSP. (handling and storage related issues) There is some Assembly process learning curve with the OSP, but in my opinion, if you are going to start working in the 0.020" pitch SMT and under arena, you should get on the curve. Kelly Kovalovsky [log in to unmask] on 08-06-98 01:27:38 PM Please respond to [log in to unmask] To: [log in to unmask] cc: Subject: [TN] HASL v/s OSP Fab/Assembly Expert: I have two questions related to price reduction if I change my pcb surface finish from HASL to OSP coating (Enthone CU106A). (1) How much price reduction (in terms of %) can I expect from fab house? (2) And also how about cost reduction from assembly house? You can provide me the range if number of layers matters. re, Ken Patel ______________________________________________________ Ken Patel Phone: (408) 490-6804 1708 McCarthy Blvd. Fax: (408) 490-6859 Milpitas, CA 95035 Beeper: (888) 769-1808 ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################ ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################