Hello.
I am looking for a safe way to straighten warped PCBs. These boards are
fully populated so I hope to be able to save them.   One method that has
been brought up is sending the boards through the wave machine with the wave
turned off and with stiffeners front and back.  Has anyone dealt with this
before? Are there any other methods out there?

Thanks,

Cam Rankin

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################