At 07:18 07/07/98 -0700, you wrote:
>  REGARDING           [TN] etch factor
>
>What is typical etch factor for 1oz Cu these days? What about 2oz? What is a
>common trace-space that suppliers see these days? Thanks.
>

May I extend that question from the assembly point of view...
and ask what overall reduction is seen on pads and traces on 1/2 oz outer layer?
Due not only to etching but also because of collimation?? tolerance.

Thanks

################################################################
TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c
################################################################
To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body:
To subscribe:   SUBSCRIBE TechNet <your full name>
To unsubscribe:   SIGNOFF TechNet 
################################################################
Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information.
For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312
################################################################