Hello all, We will be moving to no-clean processing soon, and I was concerned about the cleanliness of boards incoming from our vendor. Do I need to expect cleaner boards? What are reasonable limits to set for my board specs? How can I measure these (just with my Ohmegameter, or are there other species of contaminants that I should worry about)? I looked through the old Technet archives and didn't find too much about this. Thanks for your help, Matt Sanders Matthew Sanders PWB Procurement Engineer, Trimble Navigation Limited [log in to unmask] Phone: (408) 481-7817 Fax: (408) 481-8590 ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC's web site (http://www.ipc.org) "On-Line Services" section for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################