Try the JEDEC spec's (www.eia.org)... > -----Original Message----- > From: Kuczynski Michael [SMTP:[log in to unmask]] > Sent: Thursday, June 11, 1998 7:27 AM > To: [log in to unmask] > Subject: [TN] Unformed Leads > > Does anyone have a useful guide/spec for bending unformed leads in IC's? > > Thanks in Advance, > Michael Kuczynski 201-393-2122 (Phone) > Allied Signal 201-393-6688 (Fax) > 688 Rt46E E/K4 > Teterboro NJ 07608 > [log in to unmask] > OR > [log in to unmask] > > ################################################################ > TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c > ################################################################ > To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: > To subscribe: SUBSCRIBE TechNet <your full name> > To unsubscribe: SIGNOFF TechNet > ################################################################ > Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. > For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 > ################################################################ > ################################################################ TechNet E-Mail Forum provided as a free service by IPC using LISTSERV 1.8c ################################################################ To subscribe/unsubscribe, send a message to [log in to unmask] with following text in the body: To subscribe: SUBSCRIBE TechNet <your full name> To unsubscribe: SIGNOFF TechNet ################################################################ Please visit IPC web site (http://jefry.ipc.org/forum.htm) for additional information. For technical support contact Hugo Scaramuzza at [log in to unmask] or 847-509-9700 ext.312 ################################################################